Pete, John, and Mickey... No crane required just a couple days steady work
for two guys and easier work if I get a third person as far as dismantling
goes. I don't have a swimming pool per se but I do have 12 ponds most of
them stocked with fish. I have worked out the process for the take down and
it is not such a big deal just methodical thoughtful work with attention to
safety like keeping the climbing harness attached to something that isn't
going down imminently. Trailer handles 10,000 lbs and I estimate the
weight under 3000. Even if I were off by a factor of 2 there is no problem.
It is 120 ft of 4 1/2 inch tubing, i.e. 6 each 20 footers and a bunch of
channel iron X braces. One question that made me go hmmmm was if my welding
trailer (has the air compressor for running the impact wrenches) can
straddle the 6 pieces of tubing loaded on the trailer. I think it will
which saves me a 2+ hour round trip to fetch the welding trailer. I will
take it to the site on the HD car hauler/utility trailer to save a round
trip.
Yes, it should be clear I am not easily deterred by general from the hip
comments. I say again, this is not my first rodeo. I got the same sort of
comments when I moved one of my all steel barns (37 X 73 X 18 feet) a
quarter mile across a pasture to have it in a more convenient location. My
Hy-Gain Hy-Tower is on top of it now with no radials but great performance.
That too was the basis of all sorts of negative comments before it was
finished. Must have radials, can't install it with DIY all steel base, and
no concrete and on and on. Insurance? You betcha, plenty. I have a a farm
and ranch policy that covers the homeowners aspects and an umbrella
liability policy etc.
I'm a quarter of a mile from my nearest neighbor. The tower will meet all
code requirements structurally and electrically (auto raise and lower plus
lights for night time use of the platform and the refrigerator plus the
grill has rotisserie.
Delusional? They haven't been able to commit me so far and with my meds in
relatively good balance they never will. Ib ll post progress pix. Maybe we
should start a pool and bet on what sort of delays will occur, accidents
that will happen, injuries that will be sustained and all other dire
prognostications.
I'd like to take this opportunity to say thanks for all the "off the
reflector" supportive messages and reassure everyone sending that they may
remain anonymous so far as I am concerned. The humor of some has been a
terrific comic relief punctuating the receipt of some of these "on
reflector" messages.
I will just stay the course and post progress pix along the way. I recall
the one comment, "The difficult you do easily, the impossible takes a little
longer."
Best of 73 to you all,
Patrick AF5CK
-----Original Message-----
From: Pete Smith N4ZR
Sent: Wednesday, March 06, 2013 3:36 PM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] Relatively large tower base install questions
Just make sure you liability and home insurance are both adequate to the
risks you will incur. "$285 and some sweat equity" is a delusional
underestimate, but there clearly is no deterring you.
73, Pete N4ZR
Check out the Reverse Beacon Network at
http://reversebeacon.net,
blog at reversebeacon.blogspot.com.
For spots, please go to your favorite
ARC V6 or VE7CC DX cluster node.
On 3/6/2013 11:50 AM, Patrick Greenlee wrote:
John, I guess "expensive" or "difficult" are relative. What I have wanted
for a long time was an oil derrick but I was never in sync with the
boom-bust cycle of the oil production industry so that I could get one on
the cheap. I have a desire for an elevated observation platform and a
crank-up tower with provisions for easy antenna maint. It is possible to
separate the two items and attain them separately but I don't think that
is a superior solution.
I concur that the 40 ft tall tower base is heavy duty but for its
capability I don't think $285 and some sweat equity is expensive. I'm just
guessing at burying 15 ft or so of the crank-up below the bases 40 ft
height. If my mechanical engineer approves and we develop a plan that
mounts a free standing tower at or near the top of the 40 ft base then the
$285 buys even more functionality and reduces the cost of the crank-up
even more. We haven't explored all of the possibilities yet.
When I peruse the Texas Towers catalog prices and compare costs vs
heights/windloads I think the 40 foot tower base is a bargain so far as
offsetting the cost for height and wind load of the taller towers required
sans the platform in question. And of course there is the observation
platform function. Just imagine relaxing on a chaise lounge under a
canvas sun cover sipping a cold beverage and smelling the steaks searing
on the BBQ. Oh did I forget to mention the gas grill? and the little dorm
room size refrigerator? Also the extra 40 ft of elevation gets my line of
sight up above some brushy obstructions and puts me approximately level
with another part of my property where the targets are arrayed for our
100, 200, 300, 500, 1000 yd target range. I think the 40 foot observation
deck will make a great place from which to control RC models as well. I'm
sure when given time and not concentrating on the short term work at hand
I will think of additional uses for the tower/platform which will give it
even more versatility and value.
Patrick AF5C
-----Original Message----- From: john@kk9a.com
Sent: Tuesday, March 05, 2013 4:34 PM
To: TOWERTALK@contesting.com
Subject: Re: [TowerTalk] Relatively large tower base install questions
This sounds like a very expensive and heavy platform just to access an
antenna on your crank up tower.
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|