I used a copper mechanical connector with stainless steel shims under
one of the tower leg connector bolts on each leg of the tower.
73, Glenn - KD0Q
On 3/3/2013 10:36 AM, Jerry Gardner wrote:
AN Wireless towers don't have round cross-section legs, but rather use flat
steel bent at a 60 degree angle for the legs. Most tower grounding
solutions that I've seen use fittings that clamp onto a round tower leg.
For those of you you have installed AN Wireless (or similar towers), how
have you attached the grounding strap or wire to the tower legs at the base?
73, Jerry
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|