On my TX-455 when I take the rear bolt out the tower wants to fall back just
about half the thickness of the bolt so I keep a brick under the rear
bracing to keep it from falling back then I use a 5' section of old chrome
molly under the rear bracing and tilt it forward with one hand and let the
winch out little by little with my other hand.
John
KO4XJ
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of Rick
Karlquist
Sent: Tuesday, January 22, 2013 2:22 PM
To: Larry Loen
Cc: towertalk@contesting.com; Michael OBrien; Dana Segler
Subject: Re: [TowerTalk] The inertia of rest and the tilt over
Larry Loen wrote:
> But where do you put the lever? I don't like the place I picked. I want
> to make very sure I don't damage the tower doing the prying.
>
I put my jack under one of the rails, so I am not trying
to bend the brace between the rails.
Rick N6RK
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|