Towertalk
[Top] [All Lists]

Re: [TowerTalk] bonding to AC power box or inside fuse panel?

To: "Jeff Blaine" <keepwalking188@yahoo.com>, <towertalk@contesting.com>
Subject: Re: [TowerTalk] bonding to AC power box or inside fuse panel?
From: "Patrick Greenlee" <patrick_g@windstream.net>
Date: Mon, 21 Jan 2013 17:07:27 -0600
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Did you mean to say you were connecting the RF ground buss to the breaker panel? All the equipment tied to a single point and that single point either is or is run to round rods, metal under ground water pipes or ... But... don't hook the breaker panel ground (green wires) to the RF ground buss.

If I got it wrong, someone please explain it to me simply.

Patrick AF5CK

-----Original Message----- From: Jeff Blaine
Sent: Monday, January 21, 2013 4:51 PM
To: towertalk@contesting.com
Subject: [TowerTalk] bonding to AC power box or inside fuse panel?

Question on the optimal routing of strap to realize a single point ground.

My shack antenna entrance panel and the mains AC power meter box are along one wall b separated by about 20b. There is a ground system under the antenna entrance panel b with the usual set of polyphasers for the coax and MOV for the control lines.

The breaker boxes are on the inside of the same wall, a couple of feet below the power meter mains inlet.

The shack is centered along the same inside wall; about 5b from the breaker box on the left, and about 15b or so to the antenna entrance panel. On the shack table is a bus-bar where the gear is individually connected to in a star-configuration; one braid-type jumper from the bus bar to each shack rig or accessory.

Whatbs the best way to effect a single point ground in this combination?

I think that a single strap run from the bus-bar to the antenna entrance box. And another run from the bus-bar to the breaker box. Both of those runs would be inside the house and along the shack wall. However, I also see that itbs desirable to bond the meter to the antenna entrance panel outside of the house. Or should I do both? Or something else?

Thanks.

73/jeff/ac0c
www.ac0c.com
alpha-charlie-zero-charlie

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>