Towertalk
[Top] [All Lists]

Re: [TowerTalk] Linear Resonator

To: "towertalk@contesting.com" <towertalk@contesting.com>
Subject: Re: [TowerTalk] Linear Resonator
From: Roger Parsons <ve3zi@yahoo.com>
Reply-to: Roger Parsons <ve3zi@yahoo.com>
Date: Mon, 21 Jan 2013 07:00:44 -0800 (PST)
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Jim, K9YC wrote:
Before doing anything serious with the tower, I suggest that you first do an 
NEC model of your 160M antenna(s) including the tower and study the 
interaction.  You might find the interaction is beneficial, or not. Over the 
spring and summer I did that and found strong interaction between the tower and 
my original Tee vertical, and also between that Tee vertical and some sloping 
wires I had rigged off the tower to act as TX verticals.  Further work allowed 
me use that interaction to provide useful gain in three directions. 
73, Jim K9YC

I had already done an NEC analysis of the tower, but the physical situation is 
quite complex, and I had simplified it to make it practical to model. NEC says 
the interaction is there but not dramatic - but it thinks the tower is not much 
more than 5/8 wave in height.  The situation is quite different if the tower is 
actually an electrical three quarter wave and I really don't know whether it is 
or not.


The real tower has four sets of guys, and the first insulators are spaced out 
from the tower, so those stubs would have to be included. There are 5 different 
VHF and UHF antennas at different heights on the tower, including one that 
extends above the top, and those and their feeders would also have to be 
included. There are various brackets and lighting fixtures. I would actually 
have to measure all those distances which would mean climbing to the top of the 
tower.

The use of a linear resonator at the bottom of the tower, if it provides enough 
isolation, makes the tower appear to be ungrounded and it doesn't then much 
matter if its electrical length is 5/8 or 3/4 wavelengths. It would also be 
quite easy to do.


I'm sorry if I hadn't explained the above more clearly in my original post. I 
would still appreciate comments on whether the linear resonator would still 
work properly allowing that it could only be applied to the tower structure and 
not to the cables feeding the other antennas.

73 Roger
VE3ZI
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>