Towertalk
[Top] [All Lists]

Re: [TowerTalk] DX Engineering coax prep tool

To: "'Kelly Taylor'" <theroadtrip@mts.net>, "'TowerTalk'" <towertalk@contesting.com>
Subject: Re: [TowerTalk] DX Engineering coax prep tool
From: "Tim Duffy K3LR" <k3lr@k3lr.com>
Reply-to: k3lr@k3lr.com
Date: Fri, 11 Jan 2013 15:43:00 -0600
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Hi Kelly,

I have one of these I use all the time. I have never had this problem.
Something is not right - I suggest you call DX Engineering's help desk. I am
sure they will figure it out.

73,
Tim K3LR

-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of Kelly
Taylor
Sent: Friday, January 11, 2013 12:22 AM
To: TowerTalk
Subject: [TowerTalk] DX Engineering coax prep tool

I bought one of the DX Engineering coax prep tools (the black plastic clampy
thingy with the round finger hole).

I¹m using it with the right insert (yellow RG-213) for the right coax
(RG-213), yet the back blade, the one that¹s supposed to take off only the
black jacket, won¹t stop before cutting braid, too. I¹ve backed it out with
the adjustment screw as much as I can and it still cuts braid.

Am I missing something or is this just a POS?

Kelly
ve4xt

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>