On 12/30/12 11:45 PM, SPWoo wrote:
Hi Larry,
I ran into the same dilemma and I came up with a very simple solution. The
solution will remove about 44' of cable 'slack'. The end result is that only
about 10' of cable actually touches the ground with the tower fully retracted,
hence eliminating the need for a catch device. The 10' of cable forms a small
loop and it will rest peacefully on the ground.
The solution is to attach the last 22' of cable to the fixed tower leg with the
tower fully extended. When the tower is fully retracted an extra 22' of cable
will be suspended in the air making a total of 44' of cable out of harm's way.
At the top of the fixed tower leg you need to create a strain relief loop as
well as a small cable loop so that the cable will fall through the coax arm as
the tower is retracted.
Do you have a problem with the hanging loop blowing in the wind? Or is
the length sitting on the ground enough to keep things from getting too
tangled up.
(I have pictures in my mind of howling gales in an ice storm, with a
loop of coax flying straight out from the tower, as you are struggling
to hand crank the tower down, chipping the ice off, segment by segment..
maybe I read Two Years Before the Mast too recently...)
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|