Can't speak to your tower's size for the mounting plate. However you will
probably need to drill a new bolt hole pattern in the mounting plate for the
Yaesu rotor. In my case (a TriEx Tower) I had a rotor plate with HAM-II bolt
pattern, and had to drill new holes for the Yaesu. It was not necessary to
purchase a new mounting plate and measuring/drilling the new bolt pattern
was not a big deal.
Good luck.
73
Dan
K0DAN
-----Original Message-----
From: Roy, K1RY
Sent: December 09, 2012 08:42 AM
To: towertalk@contesting.com
Subject: [TowerTalk] G-1000 DXA & EZ-WAY RBS 40
have an EZ WAY RBS 40 Crank up/Fold Over Tower. Been up for about 2 1/2
Yaseu. On it is a KT34M2. I have been using an old CDR HAM 111 from W3PP
Estate. Well the other day the Rotor Quit. The Brake will not release. Cable
is OK to the Rotor.
My Question is Will a Yaseu G-1000 DXA fit and mount in this tower? Will the
Holes line up on the Rotor Plate?
Thanks,
Roy K1RY
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|