Henk,
Thanks so much... To all those that e-mailed with ideas (both good and bad) I
thanks you!
But since oil and water don't mix well neither does AC and DC>
Thanks again Henk!
There is no joy in Mudville!
K5IID Tom Horton Hillsboro, TX
E sorter for ARRL W5 bureau
Same call for 55 years!
--- On Fri, 11/30/12, Henk PA5KT <pa5kt@remijn.net> wrote:
From: Henk PA5KT <pa5kt@remijn.net>
Subject: Re: [TowerTalk] Yaesu Rotators
To: towertalk@contesting.com
Date: Friday, November 30, 2012, 5:02 AM
Tom,
That will not work.
The G-450 is an AC motor, the G-800 is DC.
73 Henk PA5KT
Op 28-11-2012 20:56, Tom Horton schreef:
> I don't have the schematics or data available but am curious if a Yaesu
> G-800 controller will control a Yaesu G-450 rotor.
> Thanks for any info.
> Tom K5IID
>
> There is no joy in Mudville!
>
>
>
>
>
> K5IID Tom Horton Hillsboro, TX
>
> E sorter for ARRL W5 bureau
>
> Same call for 55 years!
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|