Tom,
That will not work.
The G-450 is an AC motor, the G-800 is DC.
73 Henk PA5KT
Op 28-11-2012 20:56, Tom Horton schreef:
I don't have the schematics or data available but am curious if a Yaesu G-800
controller will control a Yaesu G-450 rotor.
Thanks for any info.
Tom K5IID
There is no joy in Mudville!
K5IID Tom Horton Hillsboro, TX
E sorter for ARRL W5 bureau
Same call for 55 years!
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|