Towertalk
[Top] [All Lists]

Re: [TowerTalk] Coax Matching Stubs W/Smith Chart

To: "'Bob K6UJ'" <k6uj@pacbell.net>, "'Tower Talk List'" <towertalk@contesting.com>
Subject: Re: [TowerTalk] Coax Matching Stubs W/Smith Chart
From: "Martin Sole" <hs0zed@csloxinfo.com>
Date: Thu, 1 Nov 2012 10:17:37 +0700
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
I recall one in a volume of the ARRL Antenna Compendium.

QRX!



-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of Bob
K6UJ
Sent: Thursday, November 1, 2012 10:15
To: Tower Talk List
Subject: Re: [TowerTalk] Coax Matching Stubs W/Smith Chart

Thanks Jerry, I found it in the handbook.

I found some on line when googling too but I want to start out at the
beginners level.  The ones I found assume you have a basic knowledge of the
Smith Chart.
Maybe I need the "dummies guide to the Smith Chart"    :-)

73,
Bob
K6UJ



On Oct 31, 2012, at 7:48 PM, Jerry Gardner wrote:

> 
> 
> On Wed, Oct 31, 2012 at 2:55 PM, Bob K6UJ <k6uj@pacbell.net> wrote:
> Can anyone recommend any tutorials for learning how to read a smith chart
and also using the Sim Smith application ?
> I want to be able to design coax matching stubs and am a total newbie.
> The smith chart is intimidating to me but I thought I would see if I could
master it.
> 
> The ARRL Antenna Book has a chapter on the use of the Smith chart. That's
a good place to start. 
> 
> 

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2013.0.2742 / Virus Database: 2617/5864 - Release Date: 10/30/12

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>