The Rohn 45G sections I have are not tapered on either end. The vertical
tubes are the same diameter from top to bottom. At the bottom of each
section, larger diameter short pieces (with an ID slightly larger than the
OD of the vertical tubes) are welded on to allow the bottom of the section
to fit onto the top of the section below. Each joint has 6 bolts, 2 per
leg. Each section weighs about 70 pounds.
73,
Marsh, KA5M
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of Larry
Melby
Sent: Thursday, October 25, 2012 2:47 PM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] Rohn 45g
Rohn 45g leg sections are tapered where one section mates to another, Rohn
45gsr
(self supporting model) uses flanges that bolt together.
73
Larry KA5TXL
________________________________
From: les <lkemble@charter.net>
To: towertalk@contesting.com
Sent: Thu, October 25, 2012 1:34:30 PM
Subject: [TowerTalk] Rohn 45g
How do I tell what type of Rohn 45 tower sections I have?
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|