To: | TOWERTALK@contesting.com |
---|---|
Subject: | [TowerTalk] Balun for an elevated vertical |
From: | Cqtestk4xs@aol.com |
Date: | Fri, 19 Oct 2012 12:40:38 -0400 (EDT) |
List-post: | <towertalk@contesting.com">mailto:towertalk@contesting.com> |
I'll be putting up a T-top elevated vertical for 160 in the next couple of days. The baser will be around 60 ft above ground and the Tee (about 40 feet long will be at about 170-180 ft...depending on the caternary sag. There will be 4 radials at 90 degrees to each other. Question: Any type of balun necessary with this? Or is it good to go. I'm using RG58 to feed it to keep the weight low on the caternary to avoid say but could wind something on a four inch PVC. Bill K4XS/KH7XS _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TowerTalk] Greasing the Tilt-over Bolts on a tilt-over tower, Larry Loen |
---|---|
Next by Date: | Re: [TowerTalk] Crank up tower bracing rubbing against cable, SPWoo |
Previous by Thread: | Re: [TowerTalk] Greasing the Tilt-over Bolts on a tilt-over tower, Larry Loen |
Next by Thread: | Re: [TowerTalk] Balun for an elevated vertical, Jim Brown |
Indexes: | [Date] [Thread] [Top] [All Lists] |