In regard to your boom truss question, you can get some horizontal
stabilization by employing a four point truss. Rather than anchoring single
truss wires directly to the mast, place a boom above the antenna such that it
is mounted to the mast perpendicular to the antenna boom. Now attach truss
wires from near the end of the antenna boom to each end of the truss support.
On another note, talk to Mark at Force 12 about a beefier antenna rated for
greater wind survivability.
Good luck in your quest to survive the Chinook winds on the front range,
Jim W5QM
________________________________
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|