Towertalk
[Top] [All Lists]

Re: [TowerTalk] Relay Box Measurements

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Relay Box Measurements
From: K8RI <K8RI-on-TowerTalk@tm.net>
Date: Sun, 26 Aug 2012 13:18:09 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
On 8/26/2012 9:54 AM, Jim Lux wrote:
> On 8/25/12 6:40 PM, Jim Brown wrote:
>> I'd like to compare data with anyone who has done careful measurements
>> of relay boxes from Array Solutions, Top Ten, and DX Engineering.  I've
>> just measured the boxes I have here, looking from 160M to 6M. Some
>> things I find acceptable and some I don't.  Some things I don't like I
>> can fix, some I can't.
>>
>
>
> when you do the measurements (using some form of VNA, I presume), do you
> cal with a set of standards with UHF connectors, or something else?
>
> (I've been thinking about measuring some stuff here, and I'm trying to
> decide whether I should try to use the UHF connectors as the measurement
> plane, or the SMA or N on the VNA test cables..)

I'm pretty new to VNAs so I just follow the manufacturer's directions.
I calibrate at the VNA (AIM 4170C)
I was looking at the whole cable run all the way to the antenna.  You 
can see just about every connector as a tiny blip.

73

Roger (K8RI)

>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>