I think I have a number of these, New Old Stock (NOS), will have to look
around in the barn, in case anyone is interested. I also have a bunch of
Phelps Dodge and Decibel products mounting hardware, not sure kit numbers,
but they consist of nice galvanized/stainless brackets & hardware that's
used to side-mount antennas, etc.
If there is any need for this stuff, I will inventory and take photos. It is
all surplus to my needs, but was "too good to throw out" and has been in
barn loft storage for 20 years.
Contact me off-list if you need stuff like this.
73
Dan
K0DAN
-----Original Message-----
From: Kimo Chun
Sent: July 26, 2012 02:41 AM
To: towertalk@contesting.com ; 'Dave Cole'
Subject: Re: [TowerTalk] Phone Pole as beam support?
Phelps-Dodge, Celwave, now RFS sells a "Pole Mount" that is made to mount a
pipe or 22' fiberglass repeater antenna directly to telephone poles (or
walls). It is made from hot-dipped galvanized 7/32" thick steel.
Old "Phelps-Dodge" P/N PD246; now Radio Frequency Systems 246 Clamp Set
Tessco SKU 15433
It comes as a pair of brackets to be spaced apart (vertically of course) on
the pole. You supply a pair of carriage bolts with backing plates to pass
through the pole. It will hold a pipe up to 2-5/8 to 2-3/4" OD. You can
adjust the spacing of the "W - wave" clamps from the U channel, that is
against the pole surface, to compensate for pole taper. The bolts holding
the clamps are 1/2"-13 x 7" long. There is a large hole in the U channel for
the carriage bolt. It will allow a 7/8" diameter bolt but there also is a
reducing bushing that allows up to a 5/8" diameter bolt.
I use these mostly on concrete walls with anchors and have used them to hold
up tribanders on masts. You could put the rotator on the end of the pipe.
Granted it reduces the capacity of rotators but in your application it may
be fine. Use more if you want more anchors to the pole spread vertically.
73, Kimo Chun KH7U
Delta Communications, Inc.
On Jul 25, 2012, at 13:58, Dave Cole <dave@nk7z.net> wrote:
> Hello,
>
> I am considering installing a phone pole to support a smallish three
> element 10-15-20 meter beam. Can someone point me at mounting methods
> for the rotor etc? A URL is fine, I have no problem looking at methods.
> I will be visiting a structural engineer tomorrow morning...
>
> --
> Thanks,
> Dave
> http://www.nk7z.net for equipment reviews, propagation, and more...
> I can melt ice with my mind... Takes a few minutes though...
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|