On 7/24/2012 9:15 PM, K8RI wrote:
I'll try and write it up tomorrow. It's a whole lot more simple than
they way they state it for Win 7 and I have a few corrections or
clarifications to make on my one post.
I'm still trying to figure out if I can set it on a frequency and use it
to adjust the antenna tuner rather than just setting up and analyzing
antennas.
At 3:58, I'm going to bed<:-))
73
Roger (K8RI)
> On 7/17/2012 2:28 PM, K8RI wrote:
>> I know we've discussed this before, but I couldn't find the specific
>> information.
>>
>> What are the best antenna analyzers for the Ham market? I'm referring
>> to both portable and computer based. I have not found the MFJ line to
>> be satisfactory. I have used one for some years.
>
> Welll... I have the AIM 4170C hooked up, but the driver in Win 7 (64
> bit) will not install for the USB/serial converter. It knows it's there
> and even properly identifies it, but can't find a driver.
>
> I've also downloaded the driver from the Internet, but it can't find it.
> There is also a self installing version of the driver which I've also
> tried. No go so far.
>
> The 858 program works fine in demo mode, but without the device driver
> there is nothing to set up or configure.
>
> 73
>
> Roger (K8RI)
>
>
> Unzip
>>
>> 73
>>
>> Roger (K8RI)
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|