To suggest a method....could a sponge be saturated
with the stuff and then rub/squeeze it on?
Charlie, N0TT
On Sun, 17 Jun 2012 13:46:26 -0700 Bob K6UJ <k6uj@pacbell.net> writes:
> OK, thats probably better than what I was doing. I had rubber
> gloves on and cupped my hand behind the cable to deflect the spray
> back on the cable.
> Seemed to work but lost a fair amount of PreLube that dripped down.
>
>
>
> Bob
> K6UJ
>
>
>
>
> On Jun 17, 2012, at 1:22 PM, Guy Molinari wrote:
>
> >
> > I held a rag behind the cable when spraying.
> >
> >> From: k6uj@pacbell.net
> >> Date: Sun, 17 Jun 2012 13:15:40 -0700
> >> To: towertalk@contesting.com
> >> Subject: [TowerTalk] best way to apply PreLube
> >>
> >>
> >> I would like to know from others in the Tower Talk group how they
> apply Prelube to their crank up tower cables.
> >> The last time I treated the cables I think only 50% made it in
> the cable, hihi.
> >> Any easy way to do this without getting PreLUbe all over the
> place ?
> >>
> >> Bob
> >> K6UJ
> >> _______________________________________________
> >>
> >>
> >>
> >> _______________________________________________
> >> TowerTalk mailing list
> >> TowerTalk@contesting.com
> >> http://lists.contesting.com/mailman/listinfo/towertalk
> >
> > _______________________________________________
> >
> >
> >
> > _______________________________________________
> > TowerTalk mailing list
> > TowerTalk@contesting.com
> > http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|