Towertalk
[Top] [All Lists]

Re: [TowerTalk] Installing ham V in 25G

To: towertalk <towertalk@contesting.com>
Subject: Re: [TowerTalk] Installing ham V in 25G
From: Steve Maki <lists@oakcom.org>
Date: Sun, 15 Apr 2012 10:32:08 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
On 4/14/2012 4:39 PM, K8RI wrote:

> I finished rebuilding the Ham V/IV  some time ago and am ready to put
> the top section on the 50' 25G.  What I've discovered is there is no way
> to fit the Ham V into the tower except lowering it down from the top.  I
> will not cut a side brace to make room nor bend one very far that can't
> be straightened to look proper.  I do not want to weaken the tower
> ...*any where*
>
> Any socially acceptable suggestions?

Make a bolt-on brace to replace what you cut out - maybe a piece of 
angle and a couple of u-bolts?

-Steve K8LX
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>