interesting Mike, I'll check it out
tnx
Bob
K6UJ
On Apr 5, 2012, at 3:55 PM, Mike wrote:
> On 4/5/12 2:35 PM, K7LXC@aol.com wrote:
>>> As I see my stack of beams swinging back and forth in the wind I am
>> thinking about adding a flexible shaft coupling above the rotor
>> to absorb the shock, I have read somewhere about using automotive drive
>> shaft flex couplings and adapt them to clamp on to
>> our 2" masts. I used to have one of Bill Orr, W6SAI books on antennas and
>> if I remember right he used one for a Volvo, and it
>> had a rubber donut between two flanges. Anyone make a flexible coupler
>> for their mast and would share what you used ?
> Yaesu makes a shock mount for their rotors. If you don't have a Yaesu
> rotor, maybe it could be adapted.
>
> http://www.yaesu.com/indexVS.cfm?cmd=DisplayProducts&ProdCatID=104&encProdID=E0526A9F285ECCF36F75CC3FEC992990&DivisionID=65&isArchived=0
>
> 73, Mike NF4L
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|