Hi AL You have no problem at all. the boxes have changed over the years but the
electrical control has not.I use to use two OLD single lever BOX so save space.
rotors were TX2's Wayne W3EA
> From: reflectors@n9isn.com
> To: towertalk@contesting.com
> Date: Sat, 17 Mar 2012 17:43:28 -0500
> Subject: [TowerTalk] Swapping HyGain Rotor Controls
>
> My analog 3 paddle control box for a Ham IV rotor (newer model MFJ) with a
> built in break delay got sick. When rotating the rotor, the 3 amp fuse
> blows and will not rotate. I swapped a analog 3 paddle rotor control box
> from a working T2X (older model pre-MFJ) to test the Ham IV rotor to see if
> the issue is with the control box or the rotor and the Ham IV works fine
> with no blown fuses.
> Can Hy-Gain rotor control boxes for Ham IV and T2X's be interchanged and
> swapped? Any damage to either rotors or control boxes for long term
> swapping? I would like to keep the Ham IV control box with the new brake
> delay with the T2X and swap the older T2X control to the Ham IV rotor.
>
> Thanks Al N9ISN
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|