All,
My Yaesu 1000 rotator stopped working today. It's locked in position and
does not move. I tried connecting another 1000DXA control box to it and
it's still dead. The connector at the rotor is clean and the cable is in
good shape.
I'd like to test the control box to see if it's working properly and
also see if I can get the rotor to spin by applying power to it. Any
trouble shooting advice would be greatly appreciated; voltages, pin-outs
etc.
Thanks,
Tony
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|