UFB cable works great for everything...direct burial and UV resistant jacket...
Ty K3MM
On 03/02/12, john@kk9a.com<kk9a@bellsouth.net> wrote:
I use house wire for the rotator motor. Since my runs are long and the motors
are large I needed a large conductor. The clear outside coating flakes off
after a few years, but otherwise house wire holds up fine on the tower.
John KK9A
To: TOWERTALK@contesting.com
Subject: Re: [TowerTalk] Romex for Rotor cable
From: Cqtestk4xs@aol.com
Date: Fri, 2 Mar 2012 07:41:29 -0500 (EST)
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
I've been using plain old 14/2 house wiring for years for rotor cable,
especially for long runs. While the life expectancy for it in sun drenched
climates is probably a little more than ten years, when buried either in
conduit or direct, it can last longer than that.
I have used it in FL and KH6 with good results.
At my new station I'm using it. The old 14/2 stuff that's weathered?
It's easily stripped into three conductors and makes great radials.
Bill K4XS
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|