Re: [TowerTalk] Yaesu G-1000DXA azimuth indicator not moving - solved

[Barry N1EU <n1eu.barry@gmail.com>]

Thanks for the responses - I found wires had broken off inside the
rotor connector from stress engendered during a recent "incident".

73, Barry N1EU

On Sat, Jan 28, 2012 at 3:47 PM, Barry N1EU <n1eu.barry@gmail.com> wrote:
> I'd appreciate troubleshooting help.  I just put my yagi back up after
> repair.  My G-1000DXA is rotating the antenna but my control box
> azimuth indicator just stays stuck in one position.
>
> Thanks & 73,
> Barry N1EU
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk