Date: Mon, 16 Jan 2012 18:43:35 -0500
From: K8RI <K8RI-on-TowerTalk@tm.net>
Subject: Re: [TowerTalk] Safe to buy 45G with a broken weld or bent
rod?
On 1/16/2012 5:31 PM, James Wolf wrote:
> What about the galvanization on the inside of the tower leg?
Where every you weld on the outside the galvanizing will likely be
burned off on the inside and likely at least half an inch farther than
the actual weld. That's why the welding is done before they hot dip
galvanize.
73
Roger (K8RI)
## somebody asked abt the inside legs. After you clean the inside legs,cap
the 3 x ends off.
Put the section on a single saw horse. use a funnel and pour a ton of that ZRC
stuff down each leg.
Then cap off the upper 3 x legs. Then rock it back and forth , like a
teeter-totter. Then flip the
tower onto a different face..and repeat the procedure. Open off 3 x caps at
one end...ONE at
a time..and pour out the excess into a container. Repeat the for the other 3
x legs. Make sure you drain
out the excess. You might be able to use paint mitts to do the outside of the
towers. Then no overspray,
which just wastes the expensive ZRC anyway. Think ZRC comes in 1 qt and also 1
gal containers.
Not doing the inside of the legs with ZRC is just asking for trbl down the
road. You can also pour ZRC
down the inside of legs on any crank up tower..while it's standing vertical.
Bit more of a trick though,
but it works.
later... Jim VE7RF
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|