On 01/04/12 12:25 pm, Tim Duffy K3LR wrote:
> A few months ago I asked a question on this reflector about tools that would
> help tighten PL-259 connectors on remote coax switches, four square boxes,
> stacking boxes, etc. Anywhere there is a tightly grouped cluster of SO-239
> connectors - that makes getting channel locks or fingers in the "nest" to
> insure the PL-259 shells are tight. It is even more problematic being on the
> tower trying to get everything tight
>
>
>
> N0AX suggested the first tool URL below - and then I found the second one on
> the Amazon site. Both tools are pretty inexpensive.
>
>
>
> http://www.amazon.com/dp/B0014WIUQY/ref=pe_175190_21431760_cs_sce_dp_f2
>
>
>
> http://www.amazon.com/dp/B001PN88NC/ref=pe_175190_21431760_cs_sce_dp_p2
>
>
>
> One of these tools goes straight on - the other has a bend for getting in
> even tighter places. These tools are what I was looking for to do the job.
>
>
>
> The only improvement would be these same two tools with a ratcheting "hold"
> to grab the connector and stay "grabbed" until release.
>
>
>
> I hope someone else can benefit from Ward's guidance.
So you've actually used both of these and found that they work well?
Alan NV8A
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|