Towertalk
[Top] [All Lists]

Re: [TowerTalk] trees and verticals

To: towertalk@contesting.com
Subject: Re: [TowerTalk] trees and verticals
From: David Gilbert <xdavid@cis-broadband.com>
Date: Tue, 27 Dec 2011 20:45:47 -0700
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Where did I say they won't work?  I said exactly the opposite.  They 
"work" even if they may be lossy simply because 1 or 2 S-units (or 
whatever the penalty may be) is still not that severe when compared to 
the relatively low power to a good antenna required to make a contact.  
I said they don't work as well as the same antenna in the clear and I 
think that is rather irrefutable unless you (or AC0C) has some 
comparison data to the contrary.  Do you?

Dave  AB7E


On 12/27/2011 7:03 PM, Jamie WW3S wrote:
> don't tell AC0C antennas in an attic wont work....
>
>
> #1   Antennas inside of an attic are often really poor performers
> precisely because there is enough stuff up there to absorb a lot of the
> RF, although not all of it is wood.  I don't think shingles are all that
> transparent to RF, for example, especially when wet.  Attic antennas do
> enable contacts, of course ... after all, even if only 5% of your 100
> watts is escaping the attic you're no worse off than if you were running
> QRP to a decent antenna.  The problem is that most people using an attic
> antenna don't have anything better to compare it against.  if they did,
> not many of them would be using the attic antenna.  Besides, wood inside
> an attic is almost always bone dry ... people used to make insulators
> out of that stuff.
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>