Sigh... This wasn't meant to be an exercise in ignoring the context!
I'm talking about a single feedline with a uniform characteristic impedence and
resonable loss, with reasonable defined as a level that does not significantly
attenuate the reflected wave. I fully realize that I've now left the term
"significantly" just dangling out there waiting to picked apart!
With respect to the context busting scenario described below: If I correctly
understand the setup, the answers are D and 50 ohms.
Merry Christmas to all!
Al
AB2ZY
-----Original Message-----
From: Paul Christensen [mailto:w9ac@arrl.net]
Sent: Saturday, December 24, 2011 10:38 AM
To: Al Kozakiewicz; towertalk@contesting.com
Subject: Re: [TowerTalk] Elevated vertical
> "Adding a matching circuit at the transmitter (tuner) or adjusting the
> length of the feedline such that a 50 ohm resistive impedence is
> presented to the source does not change the VSWR in the feedline.
> Yes, the VSWR between the source and the tuner will be 1:1, but the
> VSWR in the feedline will remain unchanged."
Sometimes VSWR does change significantly along a line -- and not always for
reasons of loss nor common-mode RF current on the outside of a coaxial line.
Consider this example:
At the operating frequency, a dipole at its input terminals is exactly 50 ohms
resistive (50+j0). Let's feed the dipole with an electrical half-wave of
low-loss 600-ohm open line. VSWR on the line is 12:1. Correct?
Finally, let's connect a random length of 50 ohm, low-loss coax to the input of
the 600 ohm line.
What is the VSWR on the 50 ohm section of line?
Possible Answers:
A. Is it still about 12:1 because VSWR does not change on a low-loss line.
B. Not enough information because you didn't state the coax length.
C It's now about 6:1
D. It is now 1:1
E. You can't terminate a coaxial line into a 600-ohm balanced line without a
current balun and get an answer.
F. None of the above.
Bonus question: What is the impedance at the input to the 600-ohm line section?
So, here we have one transmission line composed of two types. Ignoring loss,
is the VSWR really the same at all points on the transmission line?
Paul, W9AC
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|