Tony,
I've had this happen a few times. I would bypass the Polyphaser and see
what the results are. Also, if you detect a certain amount of attenuation
on your receiver, it probably is the Polyphaser.
However, my guess (given the SWR rise) is the balun.
Best Regards,
Jim N9WW
James Chaggaris
President
PowerOne Corp./PowerOne Environmental
1020 Cedar Avenue
Suite 203
St. Charles, IL 60174
Phn: 630-443-6500
Fax: 630-443-6505
Cell: 630-669-2241
website: www.pwrone.com
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Tony
Sent: Tuesday, December 20, 2011 6:41 PM
To: towertalk@contesting.com
Subject: [TowerTalk] SWR Problem Balun or lightning protection?
All,
The SWR on my 5 element mono band Yagi rises after I key down for a few
minutes. The 2:1 SWR bandwidth behaves normally until the problem
occurs. The SWR goes to normal after waiting a few minutes, but then the
problem starts again after I key down for a while.
The only things inline are the lightning protection (polyphaser) and the
balun which is mounted at the antenna. The antenna is made by M2 and it
uses an M2 balun.
I'm going to bypass the lightning protection tomorrow as a process of
elimination, but I was wondering if the problem is more likely to be
caused by the balun?
Thanks,
Tony
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|