This might work if your building officials aren't engineers, are bad at math
and ignore the load profile of the tower itself.
Wind, however, does a great job of uncovering those types of errors, if you
were unlucky enough to see wind at the design limits.
Mickey Baker
NetApp
Mobile: 954 729 6464
On Dec 6, 2011, at 4:43 PM, "Gene Fuller" <w2lu@rochester.rr.com> wrote:
>
> As I recall wind pressure "on a flat surface" at 70 mph is 20.6 lbs/sq ft.,
> so if the tower is rated for
> 18 sq ft at 70 mph, would it be too much of a stretch to say to the zoning
> board that since wind pressure at 90 mph is 34 lbs/sq ft, by simple math,
> the tower should be good for 10.9 sq ft at 90 mph ?
> Gene / W2LU
>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|