Tennadyne sells the "Slip-Not"
Best Regards,
Jim
James Chaggaris
President
PowerOne Corp./PowerOne Environmental
1020 Cedar Ave. Suite 203
St. Charles, IL 60174
Phn: 630-443-6500
Cell: 630-669-2241
Fax: 630-443-6505
Website: www.pwrone.com
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Mike
Sent: Monday, November 07, 2011 2:19 PM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] Pinning mast?
There was a gadget called "Slip-Not" (sp?) that looked interesting, but now
I can't
find a link.... anybody remember it?
73, Mike NF4L
On 11/7/2011 2:50 PM, K7LXC@aol.com wrote:
> Howdy --
>
> I've got a sloppy fit between a mast clamp and a mast - both steel.
It
> won't shim properly so I think my only option is to pin the mast. I've
> done it a bunch of times and mostly they hold butr sometimes they don't
so I'm
> proposing to use 2 in one direction and another two 90 degrees from the
> first two with good-sized high strength bolts. Other than the challenge
of
> doing it at altitude, is there anything else I should be considering? Or
is
> there another way to do it?
>
> This is a prop pitch with big antennas on it.
>
> Cheers,
> Steve K7LXC
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|