Depends on what your talking about. How tall is the tower? Is it heavily
loaded? Long boom antennas? What's on it?
73
Jim W7RY
--------------------------------------------------
From: <n8de@thepoint.net>
Sent: Sunday, October 23, 2011 5:25 PM
To: "R. Michael Barts" <mbarts@vt.edu>
Cc: <towertalk@contesting.com>
Subject: Re: [TowerTalk] Tower guying angle question
> If ALL the guys were pulling 15-degrees in the SAME direction from the
> 'norm', YES, they would put additional torque on the tower, BUT, if
> only one of them was, the amount of added torque would be minimal.
>
> 73
> Don
> N8DE
>
> Quoting "R. Michael Barts" <mbarts@vt.edu>:
>
>> The normal do-what-the-manufacturer-says installation pictures always
>> seem
>> to assume that the direction of the guys are perpendicular to the tower
>> face
>> opposite leg to which the guy is attached. I am looking at an
>> installation
>> with wall mount+ guys. But if I install guys in the conventional way, I
>> face
>> the possibility that one of the guys will interfere with a corner of the
>> house. Would it be possible (safe?) if the guy anchor points were rotated
>> 15
>> deg from the 'normal'. All three guy points would be rotated, so 120 deg
>> separation would be maintained, but would the rotated guy directions
>> place
>> any additional torque on the tower?
>>
>> 73, Mike N4GU
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|