| To: | towertalk@contesting.com |
|---|---|
| Subject: | Re: [TowerTalk] TowerTalk Digest, Vol 106, Issue 46 thrust bearing |
| From: | Spencer <k5gak@powerc.net> |
| Date: | Sat, 22 Oct 2011 11:27:01 -0600 |
| List-post: | <towertalk@contesting.com">mailto:towertalk@contesting.com> |
I think the thrust bearing subject is about the top section of ROHN 25G towers. My mast was 1.5" pipe with a sink tailpiece split spiral like and applied to the mast. Wheel bearing grease and a rubber boot. Worked very well supporting a CUBEX 5B 2L quad. I sold the quad and rotor and gave the tower away. _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TowerTalk] Fulton K2550 winch with a TRX80 Raising Fixture?, Alan NV8A |
|---|---|
| Next by Date: | Re: [TowerTalk] Wilson 40ft tubular towers, dotravel |
| Previous by Thread: | Re: [TowerTalk] Fulton K2550 winch with a TRX80 Raising Fixture?, Dino Darling |
| Next by Thread: | [TowerTalk] Needed: SWR Curves for A4S with or without 40M addon, John Crovelli |
| Indexes: | [Date] [Thread] [Top] [All Lists] |