Towertalk
[Top] [All Lists]

[TowerTalk] TX-455 holes

To: <towertalk@contesting.com>
Subject: [TowerTalk] TX-455 holes
From: "John Hudson" <jd_hudson@comcast.net>
Date: Wed, 12 Oct 2011 23:27:17 -0500
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Ok this may be irrelevant but I had a old Triesto tower that was damaged and
I replaced it with a TX-455. The Triesto had 2 bolts in each leg, and when I
tilted it over I pivoted on the bottom bolts in the front legs

 

Now on the TX-455 I installed it today and got the bottom bolts in the two
front legs in and raised it. Now the TX-455 has 3 bolts in each leg and the
other  2 holes did not align just perfect. As a matter of fact it was pretty
much a struggle to get the holes align.

 

My question is I looked on line at some photos and looks like some use the
middle holes to pivot on. Does it matter with three holes? Does it make
alignment any easier?  Was wondering if anyone else has this issue

 

Thanks

 

John

KO4XJ




 

 

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>