Towertalk
[Top] [All Lists]

Re: [TowerTalk] Tic Ring ...coax rotor loop etc

To: "'Tim Wininger'" <ky5rtim@gmail.com>, <towertalk@contesting.com>
Subject: Re: [TowerTalk] Tic Ring ...coax rotor loop etc
From: "Tim Duffy K3LR" <k3lr@k3lr.com>
Reply-to: k3lr@k3lr.com
Date: Thu, 1 Sep 2011 22:40:31 -0500
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Hi Tim!

Take a look at these photos from K3LR. No fancy over head on the boom truss,
etc. The coax rotation loop is pretty easy - with 16 TIC rings in the air -
never a broken coax!

http://www.k3lr.com/2008/CQ08PH/50.jpg

http://www.k3lr.com/2008/CQ08PH/51.jpg

Let me know if you need additional details.

73,
Tim K3LR

-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Tim Wininger
Sent: Thursday, September 01, 2011 2:33 PM
To: towertalk@contesting.com
Subject: [TowerTalk] Tic Ring ...coax rotor loop etc

Just installed three Tic Rings on three different towers (25G)
enabling me rotate lower ant on 10,15,20. I have searched the
this reflector but not much info on this. I know there are a lot of
these rings in use so how did you configure the coax so it
won't sag into the ring, won't get hung up in the guy wires etc
yet get 360deg rotation. I have my method just wonder what the so called
standard practice may be.

Any real installation experience will be much appreciated.

TNX Tim, Ky5R

obtw...Rings are new models 1016E just for 25G and booms of 30ft or less.
Using all Hy-Gain stuff 204, 155.105 hr. Assy are all aluminum and powder
coated.
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>