Must be .178?
http://www.calcentron.com/Pages/eclipse/eclipse_crimp_dies.htm
I don't know about that supplier - too cheap to be true?
I seem to have misplaced my die-set that has .255 for RG-8X, and may
have order a new one if it doesn't turn up soon :/
73,
~iain / N6ML
On Mon, Aug 15, 2011 at 9:19 PM, Pete Smith <n4zr@contesting.com> wrote:
> I am trying to figure out which die to use in a ratchet crimper for
> RG-174 - the outer ferrule, not the pin. One web reference says
> .213,but that is too large. The guys who sold me the connectors don't
> know, and the guys who sold me the crimping tool insist it should be
> .128, which is far too small. The die sizes I have jump from .213 to
> .128 with no intermediate sizes.
>
> The crimping tool that I bought is a generic Chinese type with no
> visible brand except for G and K on the two die sets I have. If I need
> another die size, any idea where I might get them?
>
> --
> 73, Pete N4ZR
>
> The World Contest Station Database, updated daily at www.conteststations.com
> The Reverse Beacon Network at http://reversebeacon.net, blog at
> reversebeacon.blogspot.com,
> spots at telnet.reversebeacon.net, port 7000
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|