Steve - I should have better defined toughness as the amount of additional
strain a material can tolerate before it reaches ultimate strength. The
later is often, but not always associated with the difference between a
material's yield and ultimate strengths.
Gary - Good to hear from you - I'll follow up off the reflector.
73
Matt
KM5VI
-----Original Message-----
From: Gary K9GS [mailto:garyk9gs@wi.rr.com]
Sent: Wednesday, July 06, 2011 11:52 PM
To: km5vi@flukey.cc
Subject: Re: [TowerTalk] Need a mast for my tower
Hi Matt!
Saw your post. How are you doing???
On 7/6/2011 10:54 PM, km5vi wrote:
> Be careful in considering aluminum as a mast material. Whereas some
> aluminum alloys offer an attractive yield strength, many do not exhibit an
> ultimate strength with much margin over yield (a.k.a. toughness) as
compared
> to carbon steel. The results can be catastrophic - the mast breaks
> relatively soon after reaching the point of bending when subjected to
> excessive strain. This is not necessarily a problem if the proper factors
> of safety are maintained, but is something to be aware of.
>
> 73 es GL
>
> Matt
> KM5VI
>
>
> -----Original Message-----
> From: towertalk-bounces@contesting.com
> [mailto:towertalk-bounces@contesting.com] On Behalf Of K8RI on TT
> Sent: Wednesday, July 06, 2011 9:14 PM
> To: towertalk@contesting.com
> Subject: Re: [TowerTalk] Need a mast for my tower
>
> On 7/6/2011 6:10 PM, STEVE LANE wrote:
>> Looking for a 20' long 2" diameter heavy wall mast. Going to have a
Force
>> 12 C19XR and a 10 meter ground plane on it. I am near the San Francisco
> Bay
>> area and can pick it up. Thanks
>>
> Check around your area for metal supply shops. I have two places, one
> within 5 miles and the other about 20. Both will deliver which
> unfortunately is no where near your location. The one place has
> Aluminum, Steel, and Copper in sheets, rods, and tube. They even carry
> DOM steel.
>
> I'm installing a C19XR with the WARC 7 above it on 2", 1/4" wall,
> 6061-T6 Aluminum tube. The WARC-7 is fairly light and only about 4 sq
> ft of wind area.
>
> 73 and good luck,
>
> Roger (K8RI)
>
>> Steve
>> K9SL
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
--
73,
Gary K9GS
Check out K9NS on the web: http://www.k9ns.com
Greater Milwaukee DX Association: http://www.gmdxa.org
Society of Midwest Contesters: http://www.w9smc.com
************************************************
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|