Hi Dick --
If you need any additional information before you open it up, you
might want to take a look at my web site. I've got several articles
on rebuilding rotators, both HAM-M and Tail-Twister models.
It's at www.hayseed.net/~jpk5lad/
Good luck on your project and 73,
Jim - K5LAD
> Before I take the Rotor apart I would like to have the Ball Bearings on hand.
>
> Can anyone tell me the diameter and material (SS or Chrome Plated) of them ?
>
> Tnx, Dick, W1KSZ
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
===============================
Life is like a football ---
It ain't round ... It'll bounce funny on ya.
http://www.hayseed.net/~jpk5lad/
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|