:::: I have always had good success using a a small scissor car
jack...go slow and be careful.. Never heard of welds being there.
BILL OWR
On 6/26/2011 2:04 PM, Warren W Munro wrote:
> For greater ease in moving an older tubular 2 section tower (probably
> TriEx, but similar or identical to current US Tower MA-series), I
> would like to separate the inner tube from the outer tube. However I
> have been warned that there may well be a welded stop to prevent folks
> from raising the upper section completely out of the inner with
> unexpected consequences hi...
>
> Has anyone tried completely separating tubular tower sections ?
>
> Are any stops accessible ?
>
> Any hints on re-cabling ?
>
> Thanks& 73
>
> Warren KH6WM
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|