I put an MOV with a cap in parallel from each line to the tower ground. I
have MOV's in the box at the bottom of the tower and also at my SPG box.
Depending on the control voltage I think that I had 19V and 56V MOV's
Mark N1UK
----- Original Message -----
From: "Kostas Stamatis" <sv1dpi@otenet.gr>
To: <towertalk@contesting.com>
Sent: Friday, 24 June, 2011 1:15 AM
Subject: [TowerTalk] control cables lightning protection
> Hello to all...
> I want to protect from lightning and static charges my rotator cable as a
> controller cable for a switch. I have seen some solutions in DXengineering
> but i would prefer a reliable homebrew solution. Anyone with some ideas?
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|