Roger (and all),
R&L makes an adapter plate to bolt a Yaesu TB to a Rohn accessory shelf (or
the flat top section). Much easier than re-drilling the top as I did.
Clint Talmadge - W5CPT
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of K8RI on TT
Sent: Sunday, June 19, 2011 12:49 AM
To: towertalk@contesting.com
Subject: [TowerTalk] Yaesu thrust bearing adapter plate to ROHN 25G
A while back we briefly discussed adapting "things" to fit other "things"
I'm currently building some adapter plates to fit Yaesu thrust bearings
(Metric) to ROHN 25G accessory shelves and thought some might find the
procedure useful as it's easily adaptable to other "things".
There are a number of photos so it may be very slow to load unless on
broadband.
http://www.rogerhalstead.com/ham_files/Adapter.htm
73
Roger (K8RI)
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|