Assuming you've tried the manufacturer with no luck, get a length of all-thread
and
bend your own. The big-box home centers stock it. Drilling the holes to 1/4"
shouldn't be a problem.
73, Mike NF4L
On 6/13/2011 12:00 AM, w3qx@qsl.net wrote:
> All
>
> An otherwise very good 70cm yagi has a boom and clamp plate with
> pre-drilled quarter-inch holes: their _centers_ are 1 and 7/8 inches
> apart. The correct u-bolt was missing.
>
> Don't ask how how many places (including McMaster) and how long I've
> looked for a u-bolt with centers of its [ends] 1 and 7/8 inches
> apart. I've learned there are about a half-dozen common u-bolt
> sizes, and for that dimension none come close.
>
> Help will be appreciated. Bolt stock section 3/16 inch should be
> good; 1/4 inch would be very tight.
>
> Best regards,
> William W3QX
>
>
>
>
> -30-
>
>
>
>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|