I bought a used TIC ring that had been used to hold a
6 element 20 meter beam. The single vertical support
had to be removed and replaced with two vertical supports
that straddle the area of the boom that is gripped by
the TIC ring. There is a horizontal bar that goes between
the two vertical posts to allow tensioning.
So you need the truss kit if your beam uses a truss.
Rick N6RK
Jorge Diez - CX6VM wrote:
> Hello,
>
>
>
> what´s the truss kit of the Tic Ring rotor for?
>
>
>
> I asked at Ticgen about a tic ring rotor, and they asked me if I need the
> truss kit, and really I don´t know. I think they must know better than me.
>
>
>
> So I will appreciate if anyone that have a Tic Ring rotor can clarify me
> the
> use of the truss kit, if it´s important or not?
>
>
>
> I´m afraid that because it´s a long piece, they want to avoid shipping it.
> But I want to do the best installation of a tic ring, so I want to know if
> it´s good to install it without the truss kit.
>
>
>
> Thanks in advance
>
>
>
> 73,
>
> Jorge
>
> CX6VM/CW5W
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|