Depending on the size needed I used a truckbed "Job Box". A big box that is
typically mounted in the bed of a pickup to hold tools. Attached is a link to
some pics when it was just going in at our house. Three years later, no
issues,
it's dry and has easy access with a lift top.
Greg
K9IG
http://k9ig.com/coppermine/displayimage.php?album=random&cat=7&pos=-59
________________________________
From: Terry G. Glagowski <TGlagowski@SBCglobal.net>
To: towertalk@contesting.com
Sent: Thu, April 14, 2011 8:00:50 PM
Subject: Re: [TowerTalk] TowerTalk Digest, Vol 100, Issue 27, Sealed container
needed for tuner
The TUPPERWARE containers lasted about 2 years at my QTH, then they got brittle
and cracked apart... but for $9 was a good try!
The grey plastic electrical boxes available at Lowes / Home Depot for about $25
might be a good bet...
They come with a rubber seal around the edges of a lid that screws on tight...
BUT... you need to put an opening for the cables... suggest you simply cut a
hole in the BOTTOM...
Perhaps glue a PVC pipe section into the hole if you want more than that...
Tightly sealed containers can lead to pressure differences with temperature and
barometric changes, and a hole lets the water from condensation OUT!
Last summer, I replaced all the TUPPERWARE boxes that surrounded junction points
at the base of towers, and installed these boxes around coax switches that were
out in the weather for 5 years... If the tuner fits in it OK, you will probably
have a good choice there...
Terry / W1TR
-----Original Message-----
From: towertalk-request@contesting.com [mailto:towertalk-request@contesting.com]
Sent: Wednesday, April 13, 2011 9:18 PM
To: towertalk@contesting.com
Subject: TowerTalk Digest, Vol 100, Issue 27
Message: 4
Date: Wed, 13 Apr 2011 19:17:14 -0500
From: chas <chasm@texas.net>
Subject: [TowerTalk] Sealed container needed for tuner
To: towertalk <towertalk@contesting.com>
Message-ID: <4DA63D0A.4050805@texas.net>
Content-Type: text/plain; charset=ISO-8859-1
I want to mount an SGC-239 tuner on the tower below a vertical. but I need a UV
proof, sealed, water tight container that I can put the tuner inside - and then
put that tuner in a tupperware? into another container if it can be
found. And all of this as cheap as possible.
I think that NMEA cases are just too expensive but that might have to be the end
choice.
thanks
chas k5dam
**
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|