On 3/24/2011 4:06 PM, Cqtestk4xs@aol.com wrote:
> A quick question:
>
> On Rohn 65 what is the distance (center to center) of the bolts on the
> flat end of each section? Am I correct thinking it is 3 inches? I am
> intersted in the distance from bolt hole to bolt hole on each side and NOT
> diagonally.
>
> I checked the Rohn site and my old Rohn book and was not able to find this
> one.
>
> Bill K4XS/KH7XS
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
Hi Bill,
I don't know if you ever received an answer to this, but you are
correct. I just measured mine and the holes are 3" center-to-center on
each side (not diagonally) and are 3/4" in diameter. I did the
measurements with a tape measure, not a micrometer, but I think the
numbers are very close. Hope this helps.
73,
Clay W7CE
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|