There are holes in the PL-259 for a reason. To solder the shield to on
the inside of the connector. See the link below.
Lots of hear "fast" is the trick. (along with flux)
http://www.seed-solutions.com/gregordy/Amateur%20Radio/Experimentation/SolderCoax.htm
73 Dave
n4zkf
On 1/21/2011 1:57 PM, Tim Duffy K3LR wrote:
> Here is an easy method to solder PL-259 connectors
>
> http://www.k3lr.com/engineering/pl259/
>
> No longer using Made in USA generics
>
> Only using the Amphenol 83-1SP - PL-259 from Mouser
>
> 73,
> Tim K3LR
>
> -----Original Message-----
> From: towertalk-bounces@contesting.com
> [mailto:towertalk-bounces@contesting.com] On Behalf Of Tom Martin
> Sent: Friday, January 21, 2011 12:45 PM
> To: towertalk@contesting.com
> Subject: [TowerTalk] Soldering PL-259
>
> A few weeks ago, I started with a 50' length of RG-213 and, after many
> attempts at soldering PL-259s, the coax was 44' long. HI!
>
> Lately, I have been ordering coax lengths with the connectors already
> soldered. I use them for runs from external antenna relays to the antennas.
>
> DIN plugs are the job that I really hate. I order a few more than I need
> because of soldering errors.
>
> 73,
>
> Tom W8JWN
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|