in the grand scheme of lightning protection going from 120v to 200v is MUCH
better than going from 120v to 200kv or more.
Jan 4, 2011 03:27:18 AM, gm3sek@ifwtech.co.uk wrote:
David Robbins wrote:
>the most important function of a whole house or similar large arrester
>serving a building is to equalize the voltage between all the
>conductors so that all the equipment connected to it is as the same
>potential.
We don't truly mean "equalize" and "same potential" here.
When MOVs conduct, they do not crowbar their two terminals together to
equalize the voltages. They act more like bidirectional zener diodes, so
they attempt to limit the applied voltage *difference*... which can
still be quite large.
In a typical US home installation, the threshold voltage of the MOVs
must be well above 115V AC to ensure that the MOVs will not conduct at
the peaks of normal line voltage. When a surge arrives and the MOVs do
begin to conduct, the clamping action is quite 'soft' so the voltage
difference between the two lines can easily exceed 200V (depending on
the source impedance from which the surge arrives).
When seen against the grand scale of lightning voltages, 200V might
conceivably be called "the same potential". But the connected equipment
doesn't share that view - it still sees the 200V across its terminals.
--
73 from Ian GM3SEK
http://www.ifwtech.co.uk/g3sek
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|