-----Original Message-----
Dan
I got mine from RF Parts and am very pleased with it, it even has a nice case.
I had an off brand
"cheap" it worked but the heads of the set screws that held the dies striped. I
use the DX
Engineering stripper, cable cutters and the little nippers to trim the braid.
Excellent.
73 Larry K1ZW
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Mike
Sent: Wednesday, December 29, 2010 6:57 AM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] Crimp tool for cable ends
On 12/28/2010 7:52 PM, Dan Evans wrote:
> I am considering taking the plunge and buying my first crimp tool to
> install coax connectors. Currently I solder all of my connectors, but
> this is a slow process and from what I have read crimp connections are
> now just as good, if not better.
>
> I normally use LMR400, RG8, or RG8X cable, and I will be installing
> PL-259's and N connectors.
>
> Can you recommend a good set of affordable crimpers? If you were buying
> a set for your station, what would you buy?
>
> Thanks,
>
> 73
> Dan
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|