On 11/11/2010 4:36 PM, Rik van Riel wrote:
> On 11/11/2010 12:25 PM, Alfred Frugoli wrote:
>> Hello everyone,
>>
>> I have 4 runs of coax for my 2 element 80M phased array that must be left
>> disconnected except for when the antenna is in use (due to the fact that the
>> center of the array where the phasing box must sit is in the middle of my
>> driveway). What's the best way to temporarily waterproof these open and
>> unused coax connectors? I'm hoping for a solution that's fairly easy to
>> do/undo so the array can be connected fairly quickly.
> The easiest way may just be to use N connectors, which are
They don't work very well once dirt (even a few grains of sand) gets in
them and if you live in an area that gets below freezing even a little
condensation can temporarily render them ...inconvenient.
73
Roger (k*RI)
> waterproof.
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|