If there is anybody within 100 miles of Lancaster Pa that has a functioning,
spare, SteppIR4 controller they are willing to sell please contact me off list
asap.
Best regards,
Scott W3TX
814-881-9258
On Nov 7, 2010, at 12:58 PM, <scottw3tx@verizon.net> wrote:
> Hello all,
> We are out here on a mountain remoting three steppIR controllers. Two of
> the controllers (controllers 1 and 2) will "frequency follow" the IC7800 via
> the CT-17 level converter. One of the controllers (controller 3) will not
> always "frequency follow" the IC7800 via the CT-17.
> Controller 3's "Option Menu" is set to follow, and it is in "General Mode".
> We have verified that the RS232 cable works on controller 1 and 2.
> If controller 3 has been unplugged a while, and we start it up, it will
> frequency follow for about three minutes, SOMETIMES.
> It is grounded.
> Yet, comparing the three controllers I have found varying degrees of ground
> continuity between RS232 board, the DB9 connector ground, the DB25 connector
> ground, and the ground lug.
> Any ideas other than getting a new controller via Fedex Next Day Air?
> 73, Scott
>
>
>
>
>
> =======
> Email scanned by PC Tools - No viruses or spyware found.
> (Email Guard: 7.0.0.18, Virus/Spyware Database: 6.16240)
> http://www.pctools.com/
> =======
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|